Dryer Vent Alarm

Did you know that a clogged dryer vent could cause a fire? The DrySafer dryer vent alarm is designed to protect your family and alert you when your dryer vent is restricted.

Protect your family from dryer fires for about 1 penny per day! **

The U.S. Consumer Product Safety Commission (CPSC) reports that there are an estimated 15,500 fires associated with dryers annually.

This dryer vent alarm can be used on any brand dryer

The DrySafer dryer vent alarm easily fits onto the back of your dryer and monitors your dryer’s airflow performance. If your dryer airflow performance drops below a safe level, the DrySafer dryer vent alarm will send out a warning signal alerting you to a potential problem in your dryer venting system.

Today, many newer homes tend to have dryers located away from an outside wall: in bedrooms, kitchens, bathrooms and hall closets. This results in longer dryer venting pipes hidden in walls and ceilings. This design increases the risk of lint accumulations inside areas that are inaccessible. The dryer has to work harder to force the air up the wall, across the ceiling to the outside exhaust hood. With DrySafer, lint accumulations are detected before a potential disaster can occur.

No special skills are required to install this alarm. In fact, it is designed to be installed by homeowners and comes with complete instructions.

How does the DrySafer dryer vent alarm work?

DrySafer Dryer Vent Alarm is made of two components; an Airflow Sensor connected by a communication cord to an Alarm Module. The Airflow Sensor monitors the flow of air in your dryer duct system, while the Alarm Module houses the electronics and communications system. The DrySafer Airflow Sensor attaches to the back of your dryer exhaust pipe and monitors the airflow out of your dryer. If an obstruction in the vent line is detected, the Airflow Sensor will monitor the restricted airflow for a period of one minute. If the obstruction is not cleared in that time period, the Airflow Sensor will alert the Alarm Module and a warning signal will sound.

When an obstruction builds up in the vent line to the point that it reduces the forward airflow, back pressure is produced. This back pressure continues to build up until the Airflow Sensor responds. The Airflow Sensor then sends a signal to the Alarm Module to sound the alarm. A series of audible tones along with visual blinking LED will signal ten beeps and blinks, followed by a 60-second delay. This will repeat until the reset button is pushed or the blockage is removed.

In the box you will find,

Complete easy to follow Installation Instructions

The Alarm Module

One 4 Inch Hose Vent Clamp

The Air Flow Sensor

The Screws and Anchors needed to mount the alarm

The A/C Power Supply

2 Mounting Brackets

Two plastic tie downs

** Since the average life of a dryer is 15 years installing
this dryer vent alarm will cost about 1 Penny per day.